Vaxcel T0199 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
T0199 / T0200
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Read and save these instructions.
Hardware Package (included):
Mounting Plate (A)
Mounting Screw (B)
Mounting Plate (A)
House Grounding Wire
Outlet Box
Green Grounding Screw (C)
Fixture Grounding Wire
Headless Screw (D)
Lock Nut (E)
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
Installation Steps
Turn off the power at fuse or circuit box.
1. Thread two headless screws through the mounting plate, and then secure them with four lock nuts (two on each side
of the mounting plate). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally to make the fixture level.
2. Attach the mounting plate to the outlet box by using two mounting screws.
3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green
grounding screw, and then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Green Grounding
Screw (C)
Wire Nut (F)
Fixture Wire
Wire Nut (F)
Photocell
Ball Nut (G)
Rubber Pad (H)
Fixture
Rubber Pad(H)
Ball Nut(G)
T0199
Bulb Type A Max.100W
(not included)
T0200
Bulb Type A Max.2-40W
(not included)
151020