Vaxcel T0103 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
T0103
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Mounting Screw (A)
Mounting Screw (B)
Important to Know:
1. If you are not familiar with state and local electrical
codes, it is recommended that you consult with a
qualified electrician.
2. This fixture requires a 120 VAC, 60 Hz power
source.
3. For general safety and to avoid any possible
damage to the sensor, be sure the power is
switched "off" before adjustment.
Maximum Wattage: 34 W
Working Temperature Range: -4
Note: Fixture can be wall mounted or eave mounted.
Wall Mounted
Light fixture and sensor should be mounted as shown above when installed (depending upon type of installation)
Before installing the light fixture under an eave, the sensor head must be rotated as shown in the next two steps for
proper operation and to avoid the risk of electrical shock.
For eave mounted only:
Swing the sensor head towards the mounting bracket.
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Mounting Screw (C) Mounting Bracket Screw (D)
0 F ~ 113 0 F
Mounting Bracket
Controls
T0103 --- Page 1 / 5
Mounting Strap (E)
Fixture Mounting Screw (F)
Features:
1. Energy saving LED fixture.
2. Motion sensor: turns light ON automatically when
motion is detected and turns light OFF automatically
when motion stops.
3. Photocell keeps the light OFF during daylight hours.
4. When in manual override mode, use wall switch
to keep the light ON during the night.
Eave Mounted
Rotate the sensor head clockwise 180˚ so the controls face down.
Controls
Wire Nut (G)
Controls
140919