Silk'n Blue Manual page 13

LED light will automatically activate.
Note that the device will not activate without skin
contact and will deactivate when removed from the skin.
Perform the treatment according to the treatment
protocol on each target area.
After 5 minutes of nonuse the device is automatically go
into STANDBY mode. To reactivate the device, push the
ON/OFF switch.
DO NOT treat the affected area for longer than the
recommended time at each session. if you treat the
affected area for longer than the recommended time
the effectiveness of the treatments may be reduced.
DO NOT treat the affected area more often than
recommended. if you treat the affected area more
often than recommended the effectiveness of the
treatments may be reduced.
When Silk'n Blue session has been completed, turn the
device off by pressing the ON/OFF Switch. All indicator
lights will be turned off.
Finally, unplug the ADAPTOR from the AC electrical
outlet, and unplug the Plug (E) from the APPLICATOR.
13