Assemble Instructions - Ink Machines Dragonfly Manual

Assemble instructions

1. Mount the excenter assembly

to the motor shaft. Make sure that the screw that engages with the motor
excenter
shaft ends on the flat part of the motor shaft.
2. Insert the motor assembly
the corresponding hole at the back of the housing.
3. Lubricate and insert the Piston

into the housing. Make sure the stay up spring aligns with the spring stop
screw

.
screw
4. Align the connecting rod

assembly
groove in the piston. Its important that there is no tension between the components.
Tighten the motor fixing screws
5. Push the piston
of the housing
the connecting rod
with the far end of a allen key
6. While holding the piston
connecting pin
circlip pliers
7. Install the noise damper o-ring
and make sure it lies firmly in the bottom. Align the inner piston

pointing up and the needlebar pin
screw
groove in the housing
8. Insert the needlebar pin
of the inner piston
housing should be 0,5mm, use a gouge or something equivalent to get the right
distance. Tighten the needlebar pin with the allen key
9. Insert the inner piston spring
Align and push the cap
10. Put the cord end of the motor cord in the hole of the clipcord bindingpost positive (

and push it in to the housing
+ )
that holds it. Tighten the contact screw cord positive ( + )
11. Install the RCA contact
touches the contact plate of the motor gently. Tighten the RCA nut gently.
12. Refit the needlebar retainer assembly
groove of the needlebar retainer
hole opposite of the retainer bearing side, trough the retainer spring and into the
second hole. Leave the retainer fix. screw end flush to the needlebar retainer surface
on the bearing side. Put the needlebar retainer assembly in the groove of the housing

and slide it back into place. Make sure that the retainer spring
correctly with the housing. Hold it in place while tightening the retainer fix. screw

.

on the motor shaft and lock the allen screw in the

into the housing


with the groove in the piston
in or out so that the connecting rod lines up with the center of the


down and insert the connecting pin

. Align the hole in the piston with the hole in the upper bearing of

. Push the connecting pin

.

at its bottom location keep pressure on the head of the

with the far end of an allen key

.


. Push it down to the noise damper o-ring

trough the groove of the housing

. The distance between the sleeve of the needlebar pin and the

, screw in the adjustment screw

in place.

and RCA nut


while aligning the motor cord to
with the stay up spring
and contact screw motor negative ( - )

trough and to its bottom location

. Install the circlip
, push it to the bottom of the hole in the piston

hole pointing in the direction of the


. Tighten the two fixing screws in the housing

by turning the RCA contact until the tip

by placing the retainer spring
. Push the retainer fix. screw

and the adjustment

. Position the motor

trough the hole in the neck

using a

with the piston

.

and trough the hole
from the top.

a few turns.

gently.


trough the first

engages

.

in the
9