Table of Contents
Advertisement
Maintenance instructions
Moving parts exposed to friction needs lubrication!
Use the oil
that were supplied with the machine and follow these steps to lubricate every
100 hours of use. Only use the oil provided with the machine, other oils may reduce lifetime
of the machine and / or clog.
1. Remove grip and needle.
2. Remove the cap
by pushing on the needlebar pin
corners between the piston and the housing. Put the cap back in place.
3. Apply oil just above the needlebar pin in the oval hole.
4. Apply oil on the bearings
few times back and forward to let the oil run into the bearings.
5. Run the machine between 9-12 volts for about a minute and clean it when done.
Service
Tools and spare parts are available on
want to do service work yourself. You can also send machines to our service technicians for a
full service. For more information go to
Warranty
This product includes a 12 month warranty from the date of purchase. The warranty applies to
factory faults and not to wear of any components caused by normal or abnormal use.
The warranty is void if:
1. Input voltage above 14 volts have been applied to the machine.
2. Machine or any of its components have been autoclaved or cleaned in a
ultrasonic cleaner.
3. Components have been damaged by misuse or carelessness.
4. Components have been manipulated.
and push the piston assembly
and lube with a small amount of oil in the
of the needlebar retainer
www.inkmachines.com
www.inkmachines.com
down to the bottom of its stroke
and roll the bearings a
in the spare parts section if you
3
Hide quick links:
Advertisement
Table of Contents
