Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Ink Machines Dragonfly
Summary of Contents for Ink Machines Dragonfly
- Page 1 Dragonfly Manual for the tattoo machine...
- Page 2 We are proud to present the Dragonfly tattoo machine. Designed with the tattoo artist in focus and manufactured with the highest quality materials and components available. The Dragonfly is a state of the art rotary based tattoo machine with features that gives it several advantages compared to other tattoo machines. The adjustable suspension system...
-
Page 3: Maintenance Instructions
Maintenance instructions Moving parts exposed to friction needs lubrication! Use the oil that were supplied with the machine and follow these steps to lubricate every 100 hours of use. Only use the oil provided with the machine, other oils may reduce lifetime of the machine and / or clog. -
Page 4: Getting Started
Getting started 1. Disconnect the machine from the power supply. . 2. Attach a new quality rubber nipple or grommet to the needlebar pin The nipple or grommet should have a tight fit with the needlebar loop. 3. Open the retainer to make clearance for the needlebar and tube by adjusting the ... -
Page 5: Troubleshooting Guide
Troubleshooting guide If you experience problems with the machine you can consult the troubleshooting guide or contact us for service at Inkmachines.com Symphtom Possible cause Possible Solution The motor does not None or to low input Increase voltage (max 14 volts). voltage. - Page 6 the housing with a plastic sleeve. If the sleeve fails short circuit will occur. Use the disassemble and assemble The motor is defect. instructions as reference. The machine won´t run The excenter is slipping Tighten the allen screw in the ...
- Page 7 The needlebar pin Relocate and tighten the needlebar moved and makes contact . Use the assemble with the housing. instructions no. 8. Clean and lubricate or replace Needlebar retainer worn or bearings clogged. Readjust needlebar retainer. Needlebar retainer hard set against needlebar.
-
Page 8: Disassemble Instructions
Too much play between the Replace pistons or complete and the inner piston piston assembly . (worn out). Use the disassemble instructions piston no. 1-6 and assemble instructions no. 3 & 5-9. The needlebar pin Lubricate. -
Page 9: Assemble Instructions
Assemble instructions 1. Mount the excenter assembly on the motor shaft and lock the allen screw in the to the motor shaft. Make sure that the screw that engages with the motor excenter shaft ends on the flat part of the motor shaft. ... -
Page 10: Specifications
Specifications Input voltage 0 - 14 volt DC (max. 14 volt DC) Power connections RCA or clipcord (max. clipcord end diam Ø1,6 mm) Rpm range 0 - 8 000 rpm / min Stitches / sec 0 - 130 / sec Stroke length 3,7 - 5 mm Suspension stroke... - Page 11 Part names Note: Parts without numbers are not included in the purchase.