The machine won´t run
but the motor
appears
to be struggling when
power is applied.
Machine looses power
and / or speed varies.
the housing with a plastic
sleeve. If the sleeve fails
short circuit will occur.
The motor
is defect.
The excenter
is slipping
on the motor shaft.
The excenter bearing
worn out.
The connecting pin
loose and making contact
with the housing.
The spring stop screw
is too far in and touching
the piston
.
The stay up spring
broken.
The piston
is clogged.
The adjustment screw
is to far up and makes
contact with the cap
Friction between housing
and piston
.
Use the disassemble and assemble
instructions as reference.
Tighten the allen screw in the
. Use the assemble
excenter
instructions no. 1.
Replace the Excenter assembly
is
. Use the disassemble
instructions no. 1 & 5-6 & 8 and
assemble instructions no. 1 & 5-9.
is
Refit the connecting pin
Circlip
. Use the assemble
instructions no. 5–6.
Adjust the spring stop screw
the bottom and loosen until it
clears the piston
is
Replace. Use the disassemble
instructions no. 1-6 and assemble
instructions no. 3 & 5-9.
Lubricate or remove the piston
and clean / lubricate. Use the
disassemble instructions no. 1-6
and assemble instructions no. 3 &
5-9.
Turn cap clockwise.
.
Lubricate according to
maintenance instructions.
and
to
.
6