Honeywell TrueZONE HZ432 Installing Manual page 2

4-zone dual fuel system, with wireless focuspro thermostats

Hide thumbs Also See for TrueZONE HZ432:

2, 3, or 4 Zone Dual Fuel System with

TrueZONE

HZ432 panel with 2-Stage Compressor and Single-Stage Furnace

Wire the HZ432

Step 1:

Step 2:

Configure the HZ432 (push the mode button on the HZ432. Follow the configuration choices shown below.

Press the connect button on the THM4000R.

Step 3:

*These options can be configured differently than shown based on user preference.

** This is the high limit for dual fuel mode. In heat-pump mode the high limit will be 120 regardless of setting.

Step 4:

Enroll the thermostats wireless sensor, and any other Redlink devices.

Step 5:

Press the "connect" button on the THM4000R to exit enrollment. Enter the installer set-up at each thermostat to

configure the thermostat for a 3H/2C heat-pump. (See thermostat installation instructions).

50-1512 RL 12/09

and Wireless FocusPRO

After the batteries are installed this

screen should come up. Use the up

arrow to change the zone number for

zones 2-4, then press "next".

This screen will come up. Use the up or

down arrow to change the zone name.

Then press "next". (52 is "thermostat"

see the wireless Focus-PRO installation

guide for other zone name choices.)

Press the connect button.

Press the done button. Repeat for all

thermostats. Then connect the outdoor

sensor and PCC.