ARTHUR HOLM DynamicShare AHDSSA User Manual page 13

AHDSSA
Options and accesories
• AHSACB:
Stand Alone control box for sharing and input selection.
VIEW push button:
2, HDMI-3, or loop shared input source. Four LEDs indicate the HDMI
local signal displayed on the monitor:
∙ LED1: HDMI1 input signal selected
∙
LED2: HDMI2 input signal selected
∙ LED3: HDMI3 input signal selected
∙
LED4: LOOP IN input signal selected. The monitor shows the
shared signal on the system.
NOTE: With the VIEW button, you can only select the input when a
valid signal is present on the HDMI input.
Share puss button:
LED indicates that the AHDSSA sends the local image to the HDMI
loop, and all the monitors display this signal. Pressing this button
again, the red LED goes off and the monitors display the local signal
on screen.
Permanent press the VIEW button during 5 seconds to activate the
private mode (green LED light is on). In private mode, the monitor
always display the local signal source selected, even if a monitor
activates the share option.
Press this button to select the local HDMI-1, HDMI-
Press this button to share the local signal. The red
13