Advertisement
Quick Links
Caution
CBS1400
Read This Guide
Before Using
Part A
Operate the scanner
with a SD Card
1. Insert a SD memory card into
the scanner's memory card slot.
Do not push USB
connector too hard into
the scanner's USB
2. Connect power to your QPIX
CBS1400 scanner via UBS cable to
AC power adapter.
connector too hard in the port.
Press Power button to turn on power.
3. Push the black lever to
"FILM" position
4. The default setting of this
scanner is for FILM.
Incorrect settings will NOT
deliver proper scan results.
Press "Menu" and Press ◀ or ▶
until "Film" appears on the
screen. Press "Enter" to enter
film type selection submenu,
press ◀ or ▶ to choose your film
size and type to be scanned
(110 or 135 size film, slide,
black&white). Press "Enter" to
port.
confirm.
5. Load your film or slides
onto the corresponding film
or slide holder. Insert the
holder into the scanner slot.
Adjust holder position to
ensure the image appears on
the screen properly. Press
"Scan" to scan the image.
You will be prompted to save
or abandon the scanned
image. If you choose to save,
the image will be
automatically saved on your
SD memory card.
Scanning film or
slides
Do not push USB
Advertisement
Related Manuals for QPIX CBS1400
Summary of Contents for QPIX CBS1400
- Page 1 2. Connect power to your QPIX CBS1400 scanner via UBS cable to AC power adapter. Do not push USB connector too hard in the port. Press Power button to turn on power. Caution Scanning film or slides 3. Push the black lever to CBS1400 “FILM”...
- Page 2 Part B computer screen Operate the scanner without a SD card 1. The QPIX CBS1400 Combo scanner has an internal memory of up to 128MB. You can operate your scanner without a SD card. See PART A steps 2 to 8 for scanning instructions.
Need help?
Do you have a question about the CBS1400 and is the answer not in the manual?
Questions and answers
How to know when the scanner is connected to the computer
To check if the QPIX CBS1400 scanner is connected to the computer:
1. Make sure the USB cable is properly connected to the computer's USB port, preferably one on the motherboard (not the front panel).
2. Turn on the scanner's power.
3. Enter USB mode by pressing the LEFT/RIGHT button to select "USB MSDC" and press ENTER to confirm.
4. The scanner should appear as a mass storage device on the computer.
If the device is connected properly, it will show up as a drive on the computer.
This answer is automatically generated