Advertisement
9. Rotate the maintenance bars to their stored position
and run the lift up and down several times to
remove any air that may have been trapped in the
hydraulic system due to shipping.
RAISING THE LIFT PLATFORM
1.
Before raising the platform, BE SURE that all others
are well clear of the lift. If the platform is loaded,
RECHECK the position and condition of the load.
2. Depress the UP button to raise the platform to a
convenient position. (See Figure 4)
Figure 4
Hand Control
CAUTION! CONTINUOUSLY WATCH the condition
of the load as the platform is raised. If the load
appears to be shifting, STOP, lower the platform
and adjust the load.
LOADING/UNLOADING THE PLATFORM
1. Check the load or component weight to ensure
the total load does not exceed the capacity of
the lift. Refer to the capacity decal on the end
of the lift platform.
2. If required, raise the platform to a convenient
working height.
3. Uniformly distribute the load over the platform or
supporting surface and ensure the load is tightly
stacked.
PAGE 4 OF 7
INSTALLATION INSTRUCTIONS CONTINUED
OPERATING INSTRUCTIONS
10. The lift is now ready for operation. Refer to the
following section for complete operating instructions.
WARNING! DO NOT concentrate the load at
one point on the pallet or platform. ALWAYS
uniformly distribute each layer of load over
the supporting surface. DO NOT use the lift
table with an unstable, unbalanced or loosely
stacked load. Unbalanced loads may become
unstable and fall. SEVERE PERSONAL INJURY and
PROPERTY DAMAGE could result.
WARNING! DO NOT overload the lift table.
ALWAYS stay within the designated capacity
ratings. SEVERE PERSONAL INJURY and PROPERTY
DAMAGE could result.
LOWERING THE LIFT PLATFORM
1.
Before lowering the platform, BE SURE that you, as
well as all others, are well clear of the lift. If the
platform is loaded, RECHECK the position and
condition of the load.
2. Depress the DOWN button to lower the lift platform.
(See Figure 4)
CAUTION! CONTINUOUSLY WATCH the condition
of the load as the platform is lowering. If the
load appears to be shifting, STOP and adjust
the load.
0413 IH-3934
Advertisement
