Advertisement
10. NEVER leave the loaded lift table unattended unless
the platform is in the fully lowered position.
11. ALL lift servicing must be performed by qualified
personnel only. Unauthorized modifications to this
lift table, its hydraulic power unit or its control system
may compromise the performance and safety of
the system. UNDER NO CIRCUMSTANCES should you
attempt any repair or service that is not covered in
this manual.
12. The release of fluids under high pressure can
cause SEVERE PERSONAL INJURY. Before servicing
the lift, ALWAYS remove all of the load, engage the
maintenance bars and RELEASE THE HYDRAULIC
PRESSURE.
13. ALWAYS ensure all safety warning labels are in place
and legible. If not, remove the lift table from service
and replace the required labels.
14. ALWAYS securely anchor the base frame to the floor
to ensure maximum stability.
CAUTION! DO NOT continue to operate the
pump if a squealing noise is heard coming
from the pump. The pressure relief valve is
operating. Continued use of the pump with the
relief valve operating may cause permanent
damage to the pump. REDUCE the load to
prevent the relief valve from operating.
The lift table is shipped on a pallet and only requires
minor assembly before it is ready for use.
Before you begin, locate and identify the components
(See Figure 1). These components will be referred to in
the installation procedures. Make sure you understand
the function of each component before proceeding.
Figure 1
PAGE 2 OF 7
SAFETY GUIDELINES CONTINUED
INSTALLATION INSTRUCTIONS
Control Cord
Disconnect Plug
Hand
Control
RECOMMENDED FLOOR AREA
The lift table's recommended floor area is a distance of
39 inches (1 meter) from the unit on all sides.
DANGER! A falling lift table can cause SEVERE
PERSONAL INJURY or DEATH. NEVER go under
the platform until the load is removed and the
scissors mechanism is secured in the raised
position with the maintenance bars. The
maintenance bars have been designed for use
only when the lift is UNLOADED. NEVER place
any load on the platform with the maintenance
bars engaged. SEVERE PERSONAL INJURY or
DEATH and PROPERTY DAMAGE could result.
Power Cord – All lift tables are supplied with an
8 ft. power cord of the proper size and rating for the
hydraulic power unit.
Power Cord Plug – All lifts are supplied with a power
cord plug for use with a conventional 115 volt
(20 amp) receptacle.
Hand Control with Control Cord Disconnect Plug –
All lift tables are supplied with a hand control
(See Figure 1) that is used to raise or lower the lift. The
control cord is 10 feet long and is supplied with a
molded control cord disconnect plug on the end.
Control Cord Disconnect Receptacle – All lift tables are
supplied with a control cord disconnect. The female
receptacle is located at the power unit end of the
base frame.
Reservoir Breather – All lift tables are supplied
with hydraulic fluid in the reservoir. The breather is
conveniently located on top of the reservoir near the
end of the lift table and must be removed to check the
fluid level or to add hydraulic fluid.
0413 IH-3934
Advertisement
