Troubleshooting - Philips AJ3431 User Manual

If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by
following these hints, consult your dealer or service centre.
WARNING:
Under no circumstances should you try to repair the set yourself, as this will invalidate the
guarantee.
PROBLEM
– POSSIBLE CAUSE
• REMEDY
No sound
– Volume not adjusted
• Adjust the VOLUME
Display error/ no reaction to any controls
– Electrostatic discharge
• Press RESET
Occasional crackling sound during FM broadcast
– Weak signal
• Adjust the position of the pigtail aerial
This product complies with the radio interference requirements of the European Union.
Continuous crackling/ hiss disturbance during
MW/ LW broadcast
– Electrical interference from TV, computer, fluorescent lamp,
mobile phone, etc.
• Move set away from other electrical equipment
The alarm does not function
– Alarm time/mode not set
• See SETTING THE ALARM
– Volume too low for ALARM 1-RADIO
• Adjust the volume
– ALARM 1-RADIO not tuned to a radio station
• Check if the set is tuned to a radio station before setting
the ALARM 1-RADIO, and when switching off

TROUBLESHOOTING

9