Related Manuals for Philips AJ3400
Summary of Contents for Philips AJ3400
- Page 1 Always there to help you Register your product and get support at www.philips.com/support AJ3400 Question? Contact Philips User manual...
-
Page 2: Table Of Contents
Contents 1 Important 2 Your clock radio What's in the box 3 Get started Install battery Connect power Set time 4 Listen to FM radio Tune to FM radio stations Store FM radio stations manually Select a preset radio station Adjust volume 5 Other features Set alarm timer... -
Page 3: Important
1 Important • Do not place any sources of danger on the clock radio (e.g. liquid filled objects, lighted candles). • Where the plug of the Direct Plug-in • Read these instructions. Adapter is used as the disconnect device, • Heed all warnings. the disconnect device shall remain readily •... -
Page 4: Your Clock Radio
3 Get started Congratulations on your purchase, and Always follow the instructions in this chapter in welcome to Philips! To fully benefit from the sequence. support that Philips offers, register your product at www.philips.com/welcome. Install battery What's in the box If there is power interruption, the clock memory backup allows your alarm and clock (Fig. -
Page 5: Connect Power
Connect power Set time Caution Note • Risk of product damage! Make sure that the power • You can only set time in standby mode. voltage corresponds to the voltage printed on the back or underside of the clock radio. •... -
Page 6: Listen To Fm Radio
4 Listen to FM Store FM radio stations radio manually You can store up to 10 FM radio stations. Tune to an FM radio station. Note Press and hold PRESET for two seconds. • Keep the clock radio away from other electronic »... -
Page 7: Other Features
5 Other features • The clock radio exits alarm setting mode when being idle for 10 seconds. Set alarm timer Select alarm source You can select FM radio or buzzer as the alarm source. (Fig. ) Set alarm » The corresponding alarm icon lights up. The AL2 setting is the same as AL1. -
Page 8: Set Sleep Timer
Press BRIGHTNESS repeatly to adjust display Distortion brightness. Signal to Noise Ratio >50 dBA General information BRIGHTNESS AC power: Brand name: Philips Power adapter A Model: SW0500500-A02; Input: 100-240 V~, 50/60 Hz max, 200 mA; Output: 5.0 V 500 mA Power adapter B Brand name: Philips;... -
Page 9: Troubleshooting
If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. -
Page 10: Notice
Hereby, Gibson Innovations declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. You can find the Declaration of Conformity on www.philips.com/ support. Disposal of your old product Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. - Page 11 This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license.