Installing Water Supply Mop Kit - Everybot Edge User Manual

Installing Water Supply Mop Kit

· Please turn o the main power when you install or detach water supply mop kits.
· Please tightly squeeze out water the mother yarn mops before attaching,
Cautions
otherwise the cleaning speed may slower down.
How to Install Water Supply Mop Kit
1
Wet mops throughly in water
and apply them in the main
unit a er wringing them out.
4
Fill water into the water tank.
Cautions
Correct Wrong
When attaching the water supply mop kit
to the main unit, refer to the right pictures.
If the mop does not attach correctly,
the mop can cover cli detection sensors
and the robot cleaner can be stopped.
2
Attach the mop pads to fit the
joint parts to the hole of water
supply mop kit.
(See the Figure below)
5
Close the rubber cap of the water supply mop kit and attach
the water supply mop kit in the bottom of the main unit.
(Pressing it while turning side to side will install it with a click sound)
Correct Wrong
When you attach the mops to water
supply mop kits, please pay attention to
attach the mop correctly to the kit without
chink. If the mop is attached in wrong
way, it may cause some malfunctions.
3
Open the rubber cap of
the water supply mop kit.
Correct Wrong
A er filling water in the water supply
mop kit, fully close the rubber cap.
If rubber cap does not close, there
will be failure or malfunction in the
robot cleaner.
7