SETTING THE ALARM TIME (See 3)
1 In any mode, press and hold ALM1 or ALM2 for two seconds.
™ ALM1 / ALM2 icon and the hour digits flash. And the icon for the current
alarm mode also flashes.
2 Hold down or press ¡1 / 2™ repeatedly to set and adjust the hours.
3 Press ALM1 or ALM2 to confirm.
™ ALM1 / ALM2 icon and the minutes digits flash. And the icon for the cur-
rent alarm mode also flashes.
4 Hold down or press ¡1 / 2™ repeatedly to set and adjust the mintues.
5 Press ALM1 or ALM2 to confirm.
SETTING THE ALARM MODE
1 Press POWER to switch to standby mode.
2 Select your choice of alarm mode: either docked player (only for Apple iPod and
Philips GoGear SA9100 and SA9200), buzzer, or radio by using the
•
DOCK
BUZZER
• At the set alarm time, the docked player (only for Apple iPod and Philips GoGear
SA9100 and SA9200) or radio or buzzer will switch on automatically.
Helpful hints:
– If you have selected TUNER alarm mode, make sure you have properly tuned to a
station before turning off the set.
– If you have selected DOCK alarm mode (only for Apple iPod and Philips GoGear
SA9100 and SA9200), make sure you have docked the compatible player, or the
buzzer mode will be selected automatically.
– To check the alarm time setting for ALM1 or ALM2, press ALM1 or ALM2.
SWITCHING OFF THE ALARM
There are three ways of switching off the alarm. Unless you cancel the alarm
completely, the 24-hour ALARM RESET will be automatically selected after 59
minutes from the time your alarm first goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish to retain
the same alarm setting for the following day:
• Press POWER.
•
TUNER slider.