Page 4
Congratulations on your purchase and welcome to Philips! To fully benifit from the support that Philips offers, register your product at www.philips.com/welcome. SUPPLIED ACCESSORIES – 1 X certified AC/DC 18V adapter ... .
Page 5
7 2; – starts/pauses playback in the dock mode – selects 12 hour or 24 hour mode 8 VOL+/- – adjusts the sound level 9 MUTE – switches playback sound off and on. 0 Display – shows clock/alarm times and status of the set ! Dock connector (30 pins) –...
POWER SUPPLY Mains adapter 1 Connect the mains adapter to the set's DC 18V socket and to the power socket. Helpful hints: To avoid damage to the set, use only the adapter supplied! The type plate is located on the bottom of the set. Remote control Important! •...
SELF-POWERED BACK-UP The self-powered back-up conveniently allows your preset stations, alarm and clock time settings to be stored for up to 10 minutes when there is a power interruption e.g. AC power failure. The complete clock radio and backlight illumination will be switched off.
SETTING THE CLOCK AND DATE 1. In any mode, press and hold TIME SET until clock digits flashes. 2. Press 2; to select 12 Hours/ 24 Hours mode. 3. Hold down or press ¡1 / 2™ repeatedly to set and adjust the hours. 4.
4 Press a PRESET button 1-5 (or PRESET 4 / 3 on the remote control) to listen to a preset station. ™ To display clock time, press 2; on the set. USING THE ALARM GENERAL Two different alarm times can be set. This can be useful when you need to be woken up at a different time e.g.
– To check the alarm time setting for ALM1 or ALM2, press ALM1 or ALM2. SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24-hour ALARM RESET will be automatically selected after 59 minutes from the time your alarm first goes off.
PLAYING APPLE iPod USING AJ300D 1 Snap the compatible iPod into the dock connector. 2 Press DOCK to switch on the dock mode. 3 The connected player will play automatically. Notes: – In dock mode, if no player is docked for 15 minutes, AJ300D will come to standby. –...
CONNECTING AN EXTERNAL DEVICE You can listen to the sound of the connected external device through your AJ300D’s speakers. 1 Press TUNER/AUX twice to select AUX mode. 2 Use the supplied AUX-IN cable to connect AJ300D’s AUX IN jack to an AUDIO OUT or headphone jack on an external equipment (such as CD player, or VCR).
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
Page 14
Docking Entertainment System Meet Philips at the Internet http://www.philips.com Printed in China PDCC-JH-AZ-0730...
Page 15
Notes for iPod connection 1. The docking entertainment system is compatible with all the existing Apple iPod models with 30-pin connector. 2. Four adaptors are included to fit different iPod models including iPod touch (8GB, 16GB), iPod classic (80GB, 160GB), iPod nano 3rd generation (4GB, 8GB), iPod the 5th generation (30GB, 60GB, 80GB), iPod nano 2nd generation (2GB, 4GB, 8GB) and iPod nano 1st generation (1GB, 2GB, 4GB ).