How To Install The Rotary Encoder (S702), Gear (Stocker Communication); How To Install The Stocker Assy - Sony CX-BK1 Service Manual

4-5.

HOW TO INSTALL THE ROTARY ENCODER (S702), GEAR (STOCKER COMMUNICATION)

Engage the rotary encoder (S702)
and the gear (stocker communication)
as shown below in the figure.
rotary encoder
(S702)
gear
(stocker
communication)
– rear –
4-6.

HOW TO INSTALL THE STOCKER ASSY

cam
To install three cams, align each groove
of the cam with each f mark on the
chassis as shown in the figure.
4 gear
(stocker communication)
3 screw
(PWH2 × 6)
1 rotary encoder
(S702)
3 screw
(PTPWH2.6 × 8)
2 cam
(stocker V)
screw
5 screw
(PTPWH2.6 × 8)
2 five solders
CONNECTOR board
boss
4 two cams
rotary encoder
(S702)
hole
1 Position the hole on the gear
gear
(stocker communication)
– rear –
CX-BK1
7 two screws
(PTPWH2.6 × 8)
6 two gears
(stocker communication)
Install the stocker assy
fitting three bosses into the
each groove of cam
then fix by rotating the cams
in the direction of arrow.
boss
5 two screws
(PTPWH2.6 × 8)
(stocker U/D)
(stocker communication) on the
screw of the rotary encoder (S702).
23