Abstract; Test Procedure; Test Flow; Software Update - Sony Ericsson K530i Test Instructions

1 Abstract

This document describes the test procedure for the Electrical repair package.

2 Test Procedure

To verify all components within the Electrical repair package, all tests must be
performed.

3 Test flow

If the phone passes these tests without any failures, it is OK to return it to the
customer.
If there are any failures, the phone must be repaired according to the troubleshooting
guide or sent to a higher repair level.
3.1

Software Update

Update to latest signalling software and run the service activities software from
EMMA III.
3.1.1

Verify Software Version

NOTE!
To verify if the phone needs new software, you have to check the Software Version in
the phone. Current Software Versions are checked through the following steps:
1. Start up the phone.
2. Enter the Service Tests Menu by pressing the sequence !!""!"! with the
navigate buttons and the ! on the keypad.
3. Select Service info.
4. Select SW Information.
5. Check the file revisions on the display.
6. Press OK to return to the Service info menu.
3.1.2

Update Software Version

Update the software in the phone by doing the following steps:
1. Make sure that the phone's battery is fully charged or use a battery eliminator.
Connect correct flash cable and interface according to the Installation instruction.
2. Logon to the EMMA III server, and follow the instructions
2/000 21-2/FEA 209 544/136 C
©
Company Internal Sony Ericsson Mobile Communications AB
Remove the SIM-card before testing.
Test Instruction, Electrical
2(11)