Table of Contents
Advertisement
Overload
The Tek-Point must not be near metal during power-on
(approximately one second). If you power it on in close
proximity to a metal object, it will enter Overload Mode.
If in Overload Mode, the following will happen:
1. Hear audio alert: BEE-BOO BEE-BOO BEE-BOO.
2. LED light flashes continuously.
3. Pinpointer will not detect metal.
To exit Overload Mode:
1. Move it away from metal.
2. Quickly press-and-release the button.
3. Pinpointer will alarm and LED stops flashing.
4. Ready to detect.
Re-Boot
If your pinpointer becomes unresponsive and/or locks up, and
any sequence of button presses does not return it to normal
operation, it's time to re-boot.
1. Remove the battery door to break battery contact.
2. Replace battery door and resume operation.
Lost Mode and Auto Shutoff
If the Tek-Point is left powered on with no button presses for
5 minutes, it will enter Lost Mode. The unit enters a low-power
setting, the LED flashes and the unit beeps every 15
seconds. After 10 minutes, the unit will completely power
down.
OPER TION
Hide quick links:
Advertisement
Table of Contents
