Zanussi ZWH71046 User Manual page 27

26 www.zanussi.com
Malfunction
There is water
on the floor:
Unsatisfactory
washing
results:
The door will
not open:
The machine
vibrates or is
noisy:
Cycle time
longer than
displayed:
The cycle is
shorter than the
time displayed.
No water is
visible in the
drum:
Possible Cause
Too much detergent or unsuitable
detergent (creates too much foam)
has been used.
Check whether there are any leaks
from one of the inlet hose fittings. It
is not always easy to see this as
the water runs down the hose;
check to see if it is damp.
The drain hose is damaged.
Water leaks inside the machine.
(code: )
Too little detergent or unsuitable
detergent has been used.
Stubborn stains have not been
treated prior to washing.
The correct temperature was not
selected.
Excessive laundry load.
The program is still running.
There is water in the drum.
This problem may be caused by a
failure of the appliance.
The transit bolts and packing have
not been removed.
The support feet have not been
adjusted.
The laundry is not evenly distributed
in the drum.
There is very little laundry in the
drum.
Unstable floors eg. wooden floors.
Detergent over dose.
Machine unbalance.
The appliance calculated a new time according to the laundry load.
Machines based on modern technology operate very economically using
very little water without affecting performance.
Solution
Reduce detergent quantity and
use correct type of detergent
(refer page 19).
Check the water inlet hose
connection.
Call Service.
Disconnect the main plug from the
main socket. Turn off the water tap.
Contact your local Service Centre.
Increase detergent quantity or use
different detergent (refer page 19).
Use commercial products to treat
the stubborn stains.
Check if you have selected the
correct temperature.
Reduce load.
Wait until the end of cycle.
You must drain the water to open
the door (refer "Opening The Door"
on page 16).
Contact Service. If you need to
open the door, please read carefully
"Emergency door opening" on next
page.
Check the correct installation of the
appliance.
Check the correct levelling of the
appliance.
Pause the machine and redistribute
laundry manually.
Load more laundry.
Refer to relevant paragraph in
"Positioning" section.
Reduce the detergent quantity or
use another one. (Refer page 19
"Detergents Type And Quantity Of
Detergent").
Redistribute laundry manually in
the drum and start the spin phase
again.