Cleaning; Resetting Factory Settings; Decommissioning; Disposal - Altec V3 IP-ALEC-42010-06 Manual

Cleaning

10 Cleaning
Only use a dry and solvent-free, soft cloth for cleaning.

11 Resetting factory settings

All settings will be lost when the factory settings are restored.
1. Keep the System key (A) pressed for 4 seconds, until it flashes rapidly in orange.
2. Release the System key.
3. Press the System key again for 4 seconds until it lights up in green.
4. Release the System key again.
9 The factory settings are reset.
9 The device restarts.

12 Decommissioning

WARNING
Danger to life due to the electrical voltage at the base station!
• Only an authorised electrician may open the device.
• Always disconnect from the mains network and secure against unintended activation before opening.
• Disconnect external voltages and secure against activation.
DK
NO
1. Loosen all connected cables.
SE
2. Uninstall the device and dispose of properly.
FI

13 Disposal

FR
Do not dispose the device with domestic waste! Electronic devices/products must be disposed
GB
GB
of according to the Directive for Waste Electrical and Electronic Equipment at the local collection
points for waste electronic equipment.
This manual is protected by copyright. All rights reserved. It may not be copied, reproduced, abbre-
viated or transmitted, neither in whole nor in parts, in any form, neither mechanically nor
electronically, without the previous consent of the manufacturer. © 2016
72