Multiple Infinitys (Artnet Control) - Infinity S601 Profile Manual

Infinity S601 Profile

Multiple Infinitys (ArtNet Control)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a CAT-5/CAT-6 cable to connect the Infinity and other devices.
04) Connect your PC with installed ArtNet software to the first device's RJ45 "in" socket.
05) Link the units as shown in fig. 07. Connect the first unit's RJ45 "out" socket with the second unit's "in"
socket, using a CAT-5/CAT-6 cable. Repeat this process to link the second, third, and fourth units.
06) Supply electric power: Plug electric mains power cords into each unit's PowerCON True1 socket,
then plug the other end of the mains power cord into proper electric power supply sockets, starting
with the first unit. Do not supply power before the whole system is set up and connected properly.
Multiple Infinitys ArtNet Set Up
Ordercode: 41507
Note : Link all cables before connecting electric power
15
Fig. 07