Cisco PA-2CT1 Installation And Configuration Manual page 31

Controller Memory Size: 8 MBytes
PA Bay 0 Information:
Token Ring PA, 4 ports
EEPROM format version 1
HW rev 1.0, Board revision B0
Serial number: 02825610
PA Bay 1 Information:
Multi-channel (T1) port adapter, 2 ports
EEPROM format version 255
HW rev FF.FF, Board revision UNKNOWN
Serial number: 4294967295
Use the show controllers cbus [type slot/port adapter/interface] command to display the internal
status of each installed interface processor and VIP2, including slot locations, hardware versions,
and the currently running microcode versions. The show controllers cbus command also lists each
interface (port), including logical interface numbers, interface types, physical (slot/port) addresses,
and hardware (station address) of each interface, and cable types attached to each interface.
The following example shows a 2CT1 port adapter installed in chassis slot 3:
Router# show controllers cbus
slot3: VIP2, hw 2.2, sw 21.40, ccb 5800FFA0, cmdq 480000C0, vps 8192
software loaded from flash slot0:muck/amcrae/vip2_21-40.mxt
FLASH ROM version 255.255
T1 3/1/1, applique is Channelized T1
gfreeq 48000138, lfreeq 48000180 (1536 bytes), throttled 0
rxlo 4, rxhi 99, rxcurr 0, maxrxcurr 0
[display text omitted]
Use the show controllers t1 command to display the status of each installed T1 interface. The
following example shows the status of a 2CT1 port adapter installed in chassis slot 3 port adapter
slot 1 interface port 0:
Router# show controller t1
T1 3/1/0 is up.
No alarms detected.
Framing is ESF, Line Code is B8ZS, Clock Source is Line.
Data in current interval (700 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Data in Interval 1:
10 Line Code Violations, 1 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 2 Line Err Secs, 0 Degraded Mins
1 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 1 Unavail Secs
Total Data (last 1 15 minute intervals):
10 Line Code Violations, 1 Path Code Violations,
0 Slip Secs, 0 Fr Loss Secs, 2 Line Err Secs, 0 Degraded Mins,
1 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 1 Unavail Secs
T1 3/1/1 is up.
No alarms detected.
Framing is ESF, Line Code is B8ZS, Clock Source is Line.
Data in current interval (700 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Data in Interval 1:
10 Line Code Violations, 1 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 2 Line Err Secs, 0 Degraded Mins
1 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 1 Unavail Secs
Part number: 73-1390-04
Part number: 255-65535-255
Channelized T1 Port Adapter Installation and Configuration
Configuring 2CT1 Interfaces
31