BUCKINGHAM MFG 26 Series Instructions & Warnings

Buckingham's 26 Series Chainsaw Lanyard (i.e. 26Y12-48) features a 1 3/4" steel ring for saw
suspension when not in use. It is constructed from an elastic bungee that contracts when relaxed and
features a tear away safety pack that activates when approximately 200 lbs. of force is applied. Model
colors, lengths and features may vary.
The 26 series tear away chain saw lanyard must be connected to a designated saddle
attachment point such as a tool ring or loop with one end, and uses the strap end to connect to
the chain saw.
INSTRUCTIONS

Lanyard Connection to Arborist Saddle

1. Use a hitch to connect the chain saw lanyard onto the side of arborist saddle.
2. Figure 1 displays a designated attachment point created between the saddle waist belt and
the back pad. Figure 2 shows the chainsaw lanyard hitched to the chain saw attachment ring
on the saddle.
3. See steps 4 - 6 to properly hitch the chain saw lanyard to the saddle.
4. Insert the 3 ½" diameter loop through either the opening that was formed between waist strap
and back pad (Fig 1) or through the ring of your saddle (Fig. 2).
Fig. 1
26SeriesWarn.doc 5/30/17)
PN 230402
BUCKINGHAM MFG.
INSTRUCTIONS / WARNINGS
P/N 26 Series
'Tear-Away' Chain Saw Lanyard
Fig. 2