Table of Contents
Advertisement
Installation/Connection
This section is for the professional installer.
For safety's sake, leave wiring and r:nounting to professionals. Consult the
car audio
dealer.
A
WARNING
• The unit can only be used with a 12 V DC power supply, negative ground.
•
Disconnect
the
battery's negative terminal before wiring and mounting.
• Do
not
connect Battery wire (yellow) and Ignition wire (red) to the
car
chassis or Ground wire (black) to prevent a short circuit
•
To prevent short circuit:
- Insulate
unconnected
wires with vinyl tape.
Be sure to ground this unit to the ca.r's chassis again after installation. ·
- Secure the wires with cable clamps and wrap vinyl tape around the
wires that comes into contact with metal parts to protect the wires
.
.• CAUTION
•
_Install this unit in the console of your vehicle. Do not touch the metal parts
of this unit during and shortly after use of the unit. Metal parts such as the
heat sink and enclosure become hot.
•
Do not connect the
8
wires of speakers to the car chassis or Ground wire
(black), or connect them in parallel.
•
Mount the unit at an angle of less than 30°.
•
If
.your
vehicle wiring harness does not have the ignition terminal, connect
Ignition wire (red) to the terminal on the vehiclers fuse box which provides
12 V DC power supply and is turned on and off by the ignition key.
•
Keep all cables away from heat dissipate metal parts.
-
•
After the unit is installed, check whether the brake lamps, blinkers, wipers,
etc. on the car are working properly.
•
If the fuse blows, first make sure the wires are not touching car's chassis,
then
replace
the old fuse with one that has the same rating.
rn
■
Basic procedure
1
Remove the key from the ignition switch, then disconnect the
8
terminal
of the car battery.
2 Connect
the
wires properly. See
"Wiring
connection" on page 3.
3 Install the unit
to
your car. See the following
"Installing
the unit
(in-dash
mounting)".
4 Connect the
8
terminal
of the car battery.
5 Press <9SRC to turn on the power.
6
Reset the unit. See
"How
to
reset"
on page 4.
(For
l•li:fAll=l#l11•l:J3.tll=ll1l•li:J.tll:1■)
Installing the unit (in-dash mounting)
~ -
Bend the appropriate tabs to hold
the sleeve firmly in place.
C)
*2
Installing in Toyota cars
Dashboard of
your car
Car bracket (Only
for illustration
purpose.)
Hide quick links:
Advertisement
Table of Contents
