Learning Steering Remote Control - Kenwood DPX794BH Instruction Manual

Display Settings
[CLOCK]
[CLOCK DISPLAY] [ON]: The clock time is shown on the display even when the unit is turned
off. ; [OFF]: Cancels.
[DEMO MODE] [ON]: Activates the display demonstration automatically if no operation is
done for about 15 seconds. ; [OFF]: Deactivates.
Preset color:
[INITIAL COLOR]/[VARIABLE SCAN]/[CUSTOM R/G/B]/[RED1]/[RED2]/[RED3]/[PURPLE1]/
[PURPLE2]/[PURPLE3]/[PURPLE4]/[BLUE1]/[BLUE2]/[BLUE3]/[SKYBLUE1]/[SKYBLUE2]/
[LIGHTBLUE]/[AQUA1]/[AQUA2]/[GREEN1]/[GREEN2]/[GREEN3]/[YELLOWGREEN1]/
[YELLOWGREEN2]/[YELLOW]/[ORANGE1]/[ORANGE2]/[ORANGERED]
34
ENGLISH

Learning Steering Remote Control

You can control the unit with the steering remote control keys on your
vehicle. After connection, you can configure the control keys according to
your preference.
• You can only make this configuration if your vehicle is equipped with the
electrical steering remote control.
• If the steering remote control in your car is not compatible, configuration
may not be completed and an error message may appear. (Page 43)
Make the connection
Steering remote cable (supplied)
Learning steering
remote input terminal
Rear panel
Configure the control keys
1 Press B SRC repeatedly to enter STANDBY.
2
Press the volume knob to enter [FUNCTION].
3
Turn the volume knob to select [SYSTEM], then press the knob.
4 Turn the volume knob to select [USER S.REMO], then press the knob.
5 Turn the volume knob to select [SET KEY], then press the knob.
A key list of 16 assignable keys appears.
• [K## NONE]: No function has been assigned.
6
Turn the volume knob to select any key from the key list to assign the
function, then press the knob.
"PRESS KEY TO ASSIGN K##" appears.
(for
Bright green/red
Purple/red
Gray/red
Connect to your vehicle's steering remote harness.
Contact your KENWOOD dealer for details.
)