RHINO WATCHGUARD DIGITAL V2 Quick Start Manual

WATCHGUARD DIGITAL V2
Quick Start Guide
Introduction:
This guide aims to give you a quick overview of the 5 basic steps required to install your Watchguard Digital Security
System, as well as its basic operation. It is important that you follow the step‐by‐step instructions detailed in the full
installation manual to ensure correct operation and full understanding of the system.
Once the locations for the main control unit and siren are chosen, connect power supplies and turn on the main control
box key switch and the siren key switch. Now test their operation before mounting the units permanently to ensure that
they are within the wireless radio range.
STEP 1.
MAIN CONTROL UNIT
Choose a convenient mounting location to install the main control
unit i.e. close to a phone outlet and power point. Drill mounting
holes (7mm Diameter) into the chosen location. Mount the unit on
the wall using the supplied screws and wall plugs.
CONNECTIONS
OFF
AC POWER
SOCKET
Power supply
Remove cover plate then connect the phone line into the left side
phone socket. If you are using a phone / fax / PC already at your
available phone point, you may plug the lead from your existing
device into the right side socket. Plug the power supply into a
power point and switch on. Straighten the wire antenna for
maximum wireless range. Now turn the main key switch to the
ON position (do not press the remotes).
Antenna
ON

STEP 2.
WIRELESS PIR DECTECTORS
Cover
Plate
When completed for each individual detector, return all the main
unit dipswitches to off to exit this test mode.
Power the detector by
opening the case and
removing the plastic insert
between the battery
terminals. Wait 3 minutes
for the detector to warm
up. During this time you
can work out where you
would like to locate your
detectors.
To test each detector's
mounting location:
Put DIP switch 1 and 3 on
the Main Control Unit up.
While holding the detector
in the mounting position
open and close the
detector case.
The main unit will beep
once. If the detector
passes, you will hear a
second set of beeps a few
seconds later. If this does
not occur, you must
reposition the detector and
retest.
Now you can mount your
detectors. Drill a 5mm
diameter hole into the wall.
Push the wall plug into the
hole then screw in the
mounting bracket. The
detector can now be
pressed onto the swivel
bracket. Re‐test the
detector by opening &
closing the case and then
walking back and forward
in front of the detector. The
main unit will beep each
time the Red PIR Detection
LED illuminates.