Table of Contents
Advertisement
POWER SUPPLY
IMPORTANT!
For best CD/MP3-CD playback, please plug in your set to an AC power supply where
•
convenient.
If operated in DC mode, see below approximate playtime. (Playtime is also varied from
•
different brand batteries) :
•
BATTERIES (NOT SUPPLIED)
Whenever convenient, use the mains supply if you want to conserve battery life. The battery supply
will be switched off when the set is connected to the mains. Make sure you remove the plug from the
set and wall outlet before inserting batteries.
Batteries
1. Open the battery compartment and insert six batteries, type
R14, UM2 or C-cells, (preferably alkaline) with the correct
polarity as indicated by the "
compartment.
Remote control
1. Open the battery door and insert two batteries,
type AAA, R03 or UM4 (preferably alkaline).
2. Replace the compartment door, making sure the batteries are
firmly and correctly in place.
3. Remove the batteries if they are exhausted or if they will not be used for a long period.
– The incorrect use of batteries can cause electrolyte leakage and will corrode the compartment
or cause the batteries to burst. Therefore:
– Do not mix battery types, e.g. alkaline with zinc carbonate.
– When inserting new batteries, replace all at the same time.
– Remove the batteries if the set is not to be used for a long time.
Note :
– The battery supply is switched off when the set is connected to the mains.
Batteries contain chemical substances, so they should be disposed of properly.
Battery type
Alkaline
Zinc Cartonate
+
-
" and "
" symbols inside the
Playtime
approximate 9 hrs
approximate 45 minutes
6 x 1.5V R14/ UM2/ C CELL
9
Advertisement
Table of Contents
