Contents 1 Important Mains fuse 2 Your CD Soundmachine Introduction What's in the box Overview of the main unit 3 Get started Connect power Turn on Turn off 4 Play Play a CD Play from an external device Play tape Tune to FM radio stations 5 Play options Control play...
1 Important • CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. • The unit shall not be exposed to dripping • Read these instructions. or splashing. • Follow all instructions. • Do not place any sources of danger on •...
2 Your CD a DBB • Turn dynamic bass boost on/off. Soundmachine b REPEAT • Play a track or all tracks repeatedly. • Start or pause play. Introduction • Turn on/off the unit. • Press to wake up the unit from With this CD Soundmachine, you can: standby mode.
AC~MAINS Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of your apparatus. The model number and serial number are on the Option 2: Battery power bottom of your apparatus.
Turn on Press . » When the source selector is in the AUDIO-IN/CD position, displayed. Switch to standby mode • The unit switches to standby mode automatically when there is no audio detected for over 15 minutes. • Press to wake up the unit from standby mode.
4 Play Play a CD Note • You cannot play CDs encoded with copyright protection technologies. You can play commercially available audio CDs: Play from an external device • CD-Recordables (CD-R) • CD-Rewritables (CD-RW) You can also listen to an external audio device Switch the source selector to AUDIO-IN/ through this unit.
Play tape Slide the source selector to TAPE. Press on main unit to open the tape door. Load the tape with the open side upward and the full spool to the right. Press on main unit to start play. • To pause/resume play, press on main unit .
5 Play options Press PROG to activate the program mode. » [PROG] (program) begin to blink. Press to select a track number, then press PROG to confirm. Control play Repeat steps 3 to program more tracks. Press to play the programmed tracks. » During play, [PROG] (program) is In CD mode, you can control play through the displayed.
6 Product Signal to Noise Ratio >50 dBA information Tape deck Frequency response 125 - 8000 - Normal tape (type I) Hz (8 dB) Note Signal-to-noise ratio 35 dBA • Product information is subject to change without prior - Normal tape (type I) notice. Wow and flutter ≤ 0.4% Specifications General Power supply 220-240V~, - AC Power 50/60 Hz;...
If the problem remains • After prolonged use, dirt or dust may unsolved, go to the Philips Web page (www. accumulate at the disc lens. To ensure good philips.com/support). When you contact Philips, play quality, clean the disc lens with Philips...
European Community. Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
Page 15
because correct disposal helps to prevent Microsoft Corporation in the United States negative consequences for the environmental and/or other countries. and human health. Environmental information Note All unnecessary packaging has been omitted. • We have tried to make the packaging easy to The type plate is located on the bottom of the apparatus.
Need help?
Do you have a question about the AZ127/12 and is the answer not in the manual?
Questions and answers