Checking The Tire Pressure; Checking The Fluid Levels; Traction Pedal; Product Overview - Toro Groundsmaster 360 31223 Operator's Manual

1. Roll bar
2. Pin
4

Checking the Tire Pressure

No Parts Required
Procedure
The tires are overinflated for shipping. Therefore,
release some of the air to reduce the pressure; refer
to Checking the Tire Pressure (page
5

Checking the Fluid Levels

No Parts Required
Procedure
1. Check the hydraulic-fluid level before starting
the engine, refer to
System (page 50).
2. Check the engine-oil level before starting the
engine, refer to Checking the Engine-Oil Level
(page 37).
3. Check the cooling system before starting the
engine; refer to Checking the Cooling System
(page 46).
Figure 5
3. Hairpin
45).
Checking the Hydraulic

Product Overview

Controls

Become familiar with all the controls before you start
the engine and operate the machine.

Traction Pedal

The traction pedal
reverse operation. Press the top of the pedal to move
forward and the bottom to move rearward. The ground
speed depends on how far you press the pedal. For
no load, maximum ground speed, fully press the pedal
g014166
while the throttle is in the F
To stop the machine, reduce the foot pressure on
the traction pedal and allow it to return to the center
position.
1. Parking brake

2. Brake pedal

Brake Pedal
Use the brake pedal with the brake-pedal latch to
engage and disengage the parking brake
6). To stop the machine, release the traction pedal
and allow it to return to the center position. You can
use the brake to assist in stopping the machine in an
emergency situation.
Tilt-Steering Pedal
To tilt the steering wheel toward you, press the foot
pedal down, pull the steering tower toward you to
the most comfortable position, and release the pedal
(Figure 6). To move the steering wheel away from
14
(Figure 6) controls the forward and
position.
AST
Figure 6
3. Tilt-steering pedal
4. Traction pedal
g197397
(Figure