SUNTEC RC 2000 Series Operating Instructions

Sunt ec
Infrared Heater
RC 2000

Remote Control

The RC 2000 series is Suntec's top of the line infrared
Heater and comes with a remote control. The Infrared tech-
nology we use in the MRC 2000 produces warm air that
blends with the air in your rooms. This recirculation produc-
es a warm environment at a very economical cost.
®
Operation very simple,just position the Heater about 6
inches from a wall and plug it in. On the front panel of
the heater you will notice a control panel. It controls the
operation of the heater.
FAN/Heater/ Pw
Press once to Turn Fan on only.
Press Twice to Turn Heat On
Press until heater turns off
Timer
Press timer button to set, in 30
minute increments, a shut off time.
You can cycle through to get back
to 0. This feature must be reset to 0
when used for normal operation. If
the time as been set it will continue
to turn off at the indicated hour un-
less the heater is turned off with
the power button.
_
+
Set the thermostat by pressing the
these buttons.

Remote Controller

Timer
See the Timer on the
remote contol panel
for details
Heater
Press to turn on the heater
FAN/Power
Press once to turn Fan on only.
Press Twice to turn the system off.
The fi rst time you turn on the heater it may produce heat. If this
happens the ambient temperature in the room my be higher then
the default temperature setting in the heater thermostat. PRESS the
Heater button then the + button until the temperature reading on
the front panel is above the ambient room temperature, the heater
will come on.
The thermostat is designed to maintain the room temperature
within 3 degrees. This means the heater will turn off when the tem-
perature you set the thermostat for is reached and will turn on when
the temperature drops 3 degrees.
The temperature displayed on the heater thermostat will vary from
the temperature displayed on the main house furnace. This is due to
the difference in the temperature of the air at the main house and
Suntec heater thermostats. The air around the Suntec thermostat
will be of a higher temperature in most cases than the air around
the main house thermostat. This is because the main system is off
and the Suntec is warming and re-circulating the air. There could be
a difference of as much as 10 degrees.This is normal and refl ects the
accuracy and the effi ciency of Suntec.
Questions Call 1-888-499-8120
email help@suntec.us
For technical questions go to www.suntec.us
_
+
Set the thermostat
by pressing the these
buttons.