Planar Dome C3i Quick Reference page 5

5
Connecting the DVI Cable and Power Cord
Use only the cable and power cord supplied with
the Dome C3i display.
1 Press the PUSH button on the desk stand
cover and remove the stand cover.
See page 9 for how to thread the cable
and cord on the desk stand.
2 Plug one end of the DVI cable into
the DVI connector port. Tighten the
thumbscrews to secure the connection.
3 Plug the power cord into the power
input port.
4 Plug the other end of the DVI cable into
the video port on the installed display
controller. Use DVI port #1 if you are
installing only one display.
5 Plug the other end of the power cord
into a grounded outlet.
6 Reattach the stand cover.
7 Power on your display first, then
the computer.
8
DVI cable
DX2 display
controller installed
DVI cable
Connection
for a single
display
Threading the DVI Cable and Power Cord
Power cord
To remove the stand cover,
press the PUSH button on the
desk stand (just above the
USB hub) and pull the stand
cover down and out to
remove it.
Thread the DVI cable and the
power cord through the back
of the stand. Make sure the
cable and cord are seated in
the notches.
To reattach the stand cover,
align the hooks with the slots
on the stand. Press the cover
into place. A click sound
signals a secure connection.
9