Section 1-Introduction; Identification Plate - Sullair DEX Series User & Service Manual

This manual contains instructions for the installation,
operation and maintenance of the
10,000 CFM ) adsorption dryer.
This manual is intended to familiarize operators
quickly with the equipment provided, its construction
and operation, and how to carry out any maintenance
when required.
Read it through carefully before commissioning the
dryer.
Record operating hours, maintenance work and
repairs etc in a logbook.
Follow all instructions carefully to ensure a trouble
free life.
Our guarantee is affected if you fail to observe the
instructions and recommendations for the operation
and maintenance of the equipment as given in this
instruction manual. Also we cannot guarantee the
equipment if it has been modified, operated with
parts other than those originally supplied or specified
in the spare parts list or if the equipment is operated
at conditions other than which it was intended and
designed for. Consult Sullair before making any
changes that may void the equipment warranty.
Our after sales service department will be happy to
provide advice, service or any spare parts that you
need.
Quote the model number, serial number and date of
manufacture on all correspondence with Sullair This
is very important, particularly when ordering spare
parts.
Sullair reserves the right to make changes or
modifications to the equipment designs without
notice.
Section 1
INTRODUCTION
DEX—(200-
DEX HEATED REGENERATIVE DRYER
1.1

IDENTIFICATION PLATE

The product identification plate shows all the primary
data of the machine. Upon installation, fill in the table
shown on the side copying the data shown on the
identification plate. These data must always be
referred to the manufacturer or to the dealer when
information or spare parts are needed, even during
the warranty period.
The removal or the alteration of the identification
plate will void the warranty rights.
Model
Serial No.
Code
Nominal Flow Rate
Max. Air Pressure
Max. Inlet Air
Temperature
Ambient
Temperature
Dessicant
(type and Qty)
Electric Supply
Electric Nominal
Power
Fuse Max.
Manufactured
Heatless Regenerative Dryer
SCFM
150 PSIG
100°F
100°F
Activated Alumina
115/110/1/50,60 208/220/1/
50,60
10W
1 AMP
—
5