Duramaxx 10029780 Manual page 18

9. Attaching the trailer to the bicycle
Pull the trailer hitch out of the drawbar and fit it onto the bicycle rear axle: on axles with
quick release, take out the whole axle, push the trailer hitch onto the nut and fit the axle
back in. On axles fastened with hexagonal nuts, unscrew the nut with washer. Push the
trailer hitch onto the axle and screw the nut back on with the washer. Connect the hitch
on the drawbar and secure the safety pin. Once the drawbar is attached, pull safety belt
through the rear end chain stay on the bicycle and hook it into the bracket on the drawbar.
Important: The connection between bicycle and trailer is the most important procedure
of the assembly process. Make sure that the trailer is securely connected to the bicycle.
If the hitch interferes with your bike or other bike attachments, or if it does not tighten
securely, do not use. Contact your bike retailer for help with proper installation.
10. Installing the jogger kit
The trailer comes with a jogger kit that allows for easy jogging when it is not attached
to the bicycle. By following the instructions below, you can convert the trailer to a jog-
ger in no time.
Insert the handle into the handle bar receiver (round tube on the back of the side
panels). Be sure to line up the holes in the handle with the holes in the handle bar
receiver to allow the safety pinto be installed. Insert and lock safety pins as shown in
the illustration below.
Insert the rectangle tube on the front fork into the rectangle tube on the front bot-
tom of the trailer. Make sure that holes on both tubes line up. Fix the front fork on the
trailer tightly by turning the black knob.
Note: Ensure that the safety pin is secured with the wrap spring clip.
18