The unit does not start
Radio stations cannot
be tuned in properly.
The remote control
does not work properly.
Cause & Correction
y The power cord is not plugged in. Plug in the power cord.
y Check whether electricity failed. Check the condition by operating other
y Check whether you select right function. Press FUNCTION and check the
y The volume is set to minimum. Use the volume controller to adjust the
y An unplayable disc is inserted. Insert a playable disc.
y No disc is inserted. Insert a disc.
y The disc is dirty. Clean the disc. (Refer to the page 17)
y The disc is inserted upside down. Place the disc with the label or printed side
y The antenna is positioned poorly. Adjust its position.
y The signal strength of the radio station is too weak. Tune to the station
y No stations have been preset or preset stations have been cleared (when
tuning by scanning preset channels). Preset some radio stations, see page 12
y The remote control is not pointed at the remote sensor of the unit. Point the
remote control at the remote sensor of the unit.
y The remote control is too far from the unit. Operate the remote control within
about 16 ft (5 m).
y There is an obstacle in the path of the remote control and the unit. Remove
y The battery in the remote control is exhausted. Replace the battery with new
2013-03-29 �� 10:26:33