Kidde SLICK RF-SFTP Installation Instructions Manual page 5

1209-7201-02(21008418)_V2:_
7. Go to the nearest unit (this will be a remote unit) and press and
release the enrol button. The amber LED will flash - 2 seconds
on and 2 seconds off (it may immediately start flashing 1-6 times
if it catches a message from the master).When it has received an
invitation from the master unit the amber LED will flash 1-6
times every 4 seconds to indicate the signal strength; a good
signal level is indicated by 3 or more flashes. If the remote is
only flashing 1 or 2 times, try rotating the wireless base or mov-
ing it away from obstructions like large metal objects and light-
ing fixtures.
8. Press the enrol button on this remote; the amber LED will blink
rapidly showing it is enrolled, and that the system is still in
enrolment mode.
9. Repeat this procedure with all other remote alarms.
10 Return to the master unit and press the enrol button. This will
cause the green LED to go out for one second in ten to indicate
the master is broadcasting.
• Failure to follow this procedure will cause the master unit to
time out after ten minutes automatically enrolling any other
compatible systems nearby that are being set up / enrolled.
11. To visually check the system is operating –
• The master unit is recognised by the green LED flashing 1
second every 10 seconds.
• A remote is recognised by a quick flash of the green LED
once every 10 seconds.
12.The system is now functional.
• If the amber LED flashes every 10 seconds it indicates that
the battery is low and will require 24 hours to become fully
charged whilst connected to the mains supply'
Pressing the enrol button during enrolment will end the process
and put the unit back into standby even if not enrolled with
other units. Any unit can be reset to its factory settings; refer
to the following section, "Resetting unit to factory condition"
for details.
Determine
location for all
alarms.
Connect all units
to AC to turn
the units on.
Press and hold
enrol button on
master unit
2011.4.19
Amber LED
flashes every 4
sec.
Press and release
enrol button on
remote unit
Amber LED on
YES
2sec./off 2 sec.
Green flashes
ever 4 sec.
4
9:13 AM Page 5
Press and release
enrol button on
remote unit
Amber LED
flashes
continuously
NO
More
remotes?
System
Enrolment
complete
Amber LEDs off,
Green LEDs flash
every 10 sec.
Press and release
enrol button on
master unit