CHERUBINI BLUE WAVE RX Instructions Manual page 5

SETTING THE A530058 POCKET REMOTE CONTROL
NB: The new pocket remote control can be set only after programming of a previous remote
control as the traditional Cherubini remote controls (Skipper - 3 buttons Up-Down-Stop
remote control).
HOW TO PROCEED TO SET THE BUTTON ON THE POCKET REMOTE CONTROL
T1: Already programmed remote control
Tn: Pocket remote control to be set
A
+ B
T1
After to have pressed for minimal 2 seconds one of the 4 buttons on the pocket remote
control, this one will be memorized on the step-by-step mode (UP-STOP-DOWN-STOP).
The following buttons will be not memorized and have to be done with previous described
sequence, and could be used to move additional Blue Wave RX motors.
DELETING ONE BUTTON ON THE POCKET REMOTE CONTROL
The buttons saved may be deleted individually according to the following sequence:
T1: Already programmed remote control
Tn: Pocket remote control with button to be deleted
A
+ B
T1
To confirm the operation the motor will do a short shunt and the button, which have to be
pressed for minimal 2 second, will be deleted.
B + C
T1
A
Tn
5
2
1
3 4
Tn (2 sec)
2
1
3 4
Tn (2 sec)
I
GB