Subscribe to Our Youtube Channel
Related Manuals for Digital Equipment turboPrintServer 20
Summary of Contents for Digital Equipment turboPrintServer 20
- Page 1 PrintServer 20 and PrintServer 32 Printer Controller Firmware Version 3.6 Upgrade Order Number: EK–LPS2X–IN. A01 Digital Equipment Corporation Maynard, Massachusetts...
- Page 2 First Printing, June 1994 Digital Equipment Corporation makes no representations that the use of its products in the manner described in this publication will not infringe on existing or future patent rights, nor do the descriptions contained in this publication imply the granting of licenses to make, use, or sell equipment or software in accordance with the description.
-
Page 3: Installing The Firmware
Installing the Firmware Installing the Firmware Version 3.6 of the controller firmware ROM chips can be installed Software in a turbo PrintServer 20 printer or a PrintServer 32 printer. Requirements This version is required when: • Booting from NetWare • If the current firmware version is older than Version 3.1 and booting is from one of the following: –... - Page 4 Installing the Firmware To install the ROM chips: Installation Procedure Disconnect the power cord from the wall outlet and then from the rear panel. Open the operator panel cover ( Loosen the two captive screws from the card cage cover and remove the cover ( ¡...
- Page 5 Installing the Firmware Extract the existing ROM chips ( ) by sliding the flat blade screwdriver underneath each chip and gently loosening the pins from their sockets. Carefully align the pins on each new chip with the sockets on the board, noting the orientation of the notch ( ¡...
Need help?
Do you have a question about the turboPrintServer 20 and is the answer not in the manual?
Questions and answers