(including damages for loss of profits, loss of business, loss of use or data, interruption of business and the like), even if PMK GmbH has been advised of the possibility of such damages arising from any defect or error in this manual or product.
Warning SKID 'eco' The Skid 'eco' must only be used for electrical equipment or components in the switched-on state that are operated at voltages max. 30 V rms or 60 V DC. Risk of injury due sharp edges (baseplate). Risk of crushing while operating the springloaded sleeve. Operating temperature: 0°C - 50°C Scope of delivery 4x holder...
Page 4
Installation guide SKID 'eco' Non conductive self-adhesive washers assembly: Pick up a washer, notice there is an open slot. Press the sleeve downwards and slide the washer around the pin. Place the adhesive towards the lower surface (picture 1). Repeat for upper side. How to use the SKID 'eco': Place the 4 magnetic holders with assembled washers onto the base plate.
Need help?
Do you have a question about the SKID eco and is the answer not in the manual?
Questions and answers