Table of Contents
Advertisement
5 Maintenance
Periodic cleaning is recommended to keep the monitor looking new and to prolong its operation lifetime. See Cleaning on
page 4
5.1 Troubleshooting
If a problem still remains after applying the suggested remedies below, contact Alphatron Marine.
5.1.1 No Picture
Problem
1. No picture
•
None of the operation buttons light up.
•
Only the
button lights up orange.
•
All of the operation buttons light up orange.
2. The message below appears.
•
This message appears when no signal is input.
(Example)
•
This message shows that the input signal is out of the
specified frequency range. (Such signal frequency is
displayed in magenta.) (Example)
fD: - Dot clock (Displayed only during digital signal
input)
fH: - Horizontal scan frequency
fV: Vertical scan frequency
47 | Maintenance
Possible cause and remedy
•
Check whether the power cord is connected properly
•
Turn the main power switch on.
•
Turn off the main powe, and then turn it on again a few
minutes later.
•
Press
.
•
Adjust the brightness (brilliance) of the screen.
•
Operate the mouse or keyboard.
•
Check whether the PC is turned on.
This message appears when the signal is not input
correctly even when the monitor functions properly.
•
The message shown left may appear, because some
PCs do not output the signal soon after power-on.
•
Check whether the PC is turned on.
•
Check whether the signal cable is connected properly.
•
Switch the input signal, see Switching Among Input
Signals on page 29
•
Check whether the PC is configured to meet the
resolution and vertical scan frequency requirements
of the monitor. ("Compatible Resolutions" in the Setup
Manual.)
•
Reboot the PC.
•
Select an appropriate display mode using the graphics
board's utility. Refer to the User's Manual of the
graphics board for details.
Advertisement
Table of Contents
