Tuner - Philips FW-C55/22 User Manual

TUNER

MINI HIFI SYSTEM
PROGRAM SHUFFLE
REPEAT TIMER REC
AM MW FM LW
NEWS T.A.
60Hz 250Hz
STANDBY
ON
CLOCK/
CD1 • 2 • 3 BAND
TIMER
CD TUNER
PROG
SEARCH • TUNING STOP•CLEAR
SOUND NAVIGATION
INCREDIBLE
SURROUND
DIGITAL
SOUND CONTROL
Note:
– For 'EASY SET' feature, please refer to
page 11.
Tuning to radio stations
1 Press TUNER (BAND) to select TUNER
mode.
™ "TUNER" will be displayed.
A few seconds later, the current radio
frequency will be displayed.
2 Press TUNER (BAND) again to select
the desired waveband : FM, MW or LW.
3 Press à or á for more than one
second, then release.
™ The display will show "SEARCH"
until a radio station with sufficient
signal strength is found.
16
pg 01-26/C55/22-Eng new 16
STEREO
BACK
FRONT HSD
500Hz 1KHz 2KHz 4KHz 8KHz
RDS
NEWS/TA
TAPE 1 • 2 CDR/VIDEO
TAPE AUX
A. REV
PRESET
PLAY PAUSE PREV SIDE NEXT
MIC
LEVEL
DYNAMIC BASS
MIC
BOOST
• Repeat this procedure until the desired
station is reached.
• To tune to a weak station, briefly press
à or á repeatedly until the display
shows the desired frequency and/or
when the best reception has been
obtained.
Storing Preset Stations
You can store up to 40 radio stations in the
memory. When a preset radio station is
selected, the preset number appears next
to the frequency on the display.
Automatic programming
1 Press TUNER (BAND).
2 Press PROG for more than one second.
™ The starts flashing and
PROGRAM
"AUTO" will be displayed.
™ The system will start searching for all
radio stations with RDS and then
followed by radio stations on FM,
MW and LW band respectively.
™ All available stations will be stored
automatically. The frequency and
preset number will be displayed
briefly.
™ The system will stop searching when
all the available radio stations are
stored or when the memory for 40
preset radio stations is used.
™ The system will remain tuned to the
last stored preset radio station.
Notes:
– You can cancel the automatic
programming by pressing PROG or Ç
(on the system only).
– If you want to reserve a section of
preset numbers, for example preset
numbers 1 to 9, select preset 10 before
starting automatic programming, only
the preset numbers 10 to 40 will be
programmed.
3/6/00, 11:43 AM
Manual programming
1 Press TUNER (BAND).
2 Press TUNER (BAND) again to select
the desired waveband : FM, MW or LW.
3 Press PROG for less than one second.
™ The starts flashing.
PROGRAM
™ The next available preset number will
be displayed for selection.
4 Press à or á to tune to the desired
frequency.
• If you wish to store the radio station to
another preset number, press 4 or 3 to
select the desired preset number.
5 Press PROG again.
™ The disappears and the
PROGRAM
radio station will be stored.
• Repeat steps 3 – 5 to store other preset
radio stations.
Notes:
– When 40 radio stations are stored and
you attempt to store another radio
station, the display will show " FULL ".
If you want to change an existing preset
number, repeat steps 3 – 5.
– You can cancel manual programming by
pressing Ç (on the system only).
– During programming, if no button is
pressed within 20 seconds, the system
will exit program mode automatically.
3139 116 19551