Vaxcel T0130 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
T0130 / T0134
WARNING:
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Parts:
Cross Bar (A)
Mounting Screw (B)
Cross Bar (A)
Lock Nut (F)
Outlet Box
Green Grounding Screw (C)
House Grounding Wire
Fixture Grounding Wire
IMPORTANT:
The sensor has an excellent photocell function to
enable the light to turn on at dusk and off at dawn
automaticlly.
Installation Steps
Turn off the power at the main fuse or circuit breaker box.
1. Thread two headless screws through the cross bar, then secure them with four lock nuts ( two on each side of the
cross bar). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally, to ensure that the fixture will be level.
2. Attach the cross bar to the outlet box by using two mounting screws.
3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follow:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Headless Screw (D)
Green Grounding
Screw (C)
Headless Screw (D)
Photocell
Back Plate
Fixture Wire
Wire Nut (E)
Rubber Pad (H)
Ball Nut (G)
Lock Nut (F)
Wire Nut (E)
Finial
Rubber Pad
Fixture
Bulb Type A Max.60W
(not included)
Ball Nut (G)
Rubber Pad (H)
Glass Panel
Frame
141029