Commissioning; Inserting The Back-Up Batteries; Antenna; Additional Audio Device - Silvercrest KH2352 Operating Instructions Manual

Commissioning

Unpacking the device
• Remove all packaging material.
Attention!
Do not permit small children to play with plastic
packaging. There is a risk of suffocation!
Check the items supplied
Whilst unpacking, check that all of the following
items are available to you:
- Compact radio
Placement
• Place the radio on a level and horizontal surface.

Inserting the back-up batteries

With back-up batteries fitted, the adjusted timings
will not be lost in the event of a power failure.
For this, you require two 1.5V batteries of the type
Micro AAA/R03 (not supplied).
1. Open the flap of the battery compartment on the
rear of the radio.
2. Insert the batteries. Make sure the polarities are
correct.
3. Replace the flap of the battery compartment.
The flap must audibly engage.
Note:
When the device is separated from mains power
the time is not displayed, however, the internal
clock continues to run.

Antenna

The swivelling telescope aerial on the device is
effective in the FM transmission range.
• Completely withdraw and extend the aerial
and then adjust it into the position for the best
possible reception.
The telescope aerial does not function in the MW
transmission range. In these ranges, reception is
made by the built-in ferrite aerial.
• Position the device for the best possible recep-
tion.

Additional audio device

You can connect additional audio devices to the
radio, for example, an MP3 player, for playback
through the radio.
• Connect the stereo jackplug of the audio device
with the socket AUX on the rear of the device.

Power supply

• When all of the required connections have been
made, insert the plug on the power cable into
a wall power socket. The device is now in stand-
by and the time is shown in the display.
If the time has not yet been programmed in, it
begins with 0:00. In this case, programme in
the time as described in the next section.

Setting the time

1. In standby, press and hold the button
2. Enter in the hour by repeatedly pressing on the
HOUR
button .
3. Enter in the minutes by repeatedly pressing on
MIN
the button .
4. Release the button
now programmed.
Note:
So that the time is saved in the event of a power failure
or withdrawal of the plug, the back-up batteries
must be inserted.
- 5 -
TIME SET
TIME SET
. The time display is
.