Entering And Exiting The Programming Mode - Sentex SPECTRUM Series Programming Instructions Manual

2 - ENTERING AND EXITING THE PROGRAMMING MODE

ENTERING THE PROGRAMMING MODE
The programming password is a 6-digit number. The password is set to "000000" at the
factory, but your installer may have changed it during installation. When you are comfortable
with programming, you should change the password to maintain the security of your system.
Make a note of the new password so you do not forget it.
To enter the programming mode from the keypad, enter three asterisks "∗∗∗" followed by the
six-digit password. The unit will respond with 2 short beeps.
EXITING THE PROGRAMMING MODE
After you have completed programming your system, exit the programming mode by
pressing "00" + "#."
Rev A Doc 6001573 Page 3 of 15