Table of Contents
Advertisement
Radio Reception
DISPLAY/BAND
Tuning to radio stations
1
Select TUNER source.
2
Press DISPLAY/BAND on the set repeatedly
or press TUNER on the remote repeatedly
until the desired waveband (FM or MW) is
displayed.
3
Press down on TUNING 4 ¢ and release
button.
The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning: Srch.
4
Repeat step 3 if necessary until you find the
desired station.
To tune to a weak station, press TUNING 4
¢ briefly and repeatedly until you have found
optimal reception.
Programming radio stations
You can store up to a total of 20 radio stations (
10 for FM and 10 for MW respectively) in the
memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden. The system will only programme
stations which are not in the memory already.
1
Press ALBUM/PRESET 4 3 to select the
preset number where programming should start.
14
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROGRAM for more than 2 seconds to
activate programming.
AUTO is displayed and available stations are
programmed in order of waveband reception
strength. The first preset automatically stored will
then be played.
Manual programming
1
Tune to your desired station (see Tuning to radio
stations).
2
Press PROGRAM to activate programming.
flashes in the display.
PROG
3
Press ALBUM/PRESET 4 3 to allocate a
number from 1 to 10 to this station.
4
Press PROGRAM again to confirm the setting.
disappears, the preset number and the
PROG
frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations.
You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
Press ALBUM/PRESET 4 3 until the desired
preset station is displayed.
Changing tuning grid
only)
In North and South America the frequency step
between adjacent channels in the MW and FM
band are 10 KHz and 100 KHz respectively. In
the rest of the world this step is 9 KHz and 50
KHz. Usually the frequency step has been preset
in the factory for your area if not:
1
Select TUNER source.
2
Press CLOCK SET on the set for at least 5
seconds.
Note:
– All preset stations will be lost and need to be
reprogrammed.
(some versions
Advertisement
Table of Contents
