Radio Reception; Tuning To Radio Stations; Programming Radio Stations; Automatic Programming - Philips MCM390/22 User Manual

Radio Reception

Tuning to radio stations

1
Select TUNER source.
"TUNER" is displayed briefly.
2
Press DISPLAY/BAND to select the desired
waveband : FM, MW or LW.
3
Press down on S or T ( à or áon
the remote control) and release button.
The display will show "SEARCH" until a radio
station with sufficient signal strength is found.
If a FM station is received in stereo,
shown.
4
Repeat step 3 if necessary until you find the
desired station.
To tune to a weak station, press S or T
( ¡ or ™ on the remote control) briefly and
repeatedly until you have found optimal
reception.
14

Programming radio stations

You can store up to a total of 40 radio stations
in the memory.

Automatic programming

Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
1
Press 4 or 3 to select the preset number where
programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROGRAM for more than two seconds
to activate programming.
All available stations are programmed.

Manual programming

1
Tune to your desired station (refer to "Tuning to
radio stations").
2
Press PROGRAM to activate programming.
PROG flashes in the display.
is
3
Press 4 or 3 to allocate a number from 1 to 40
to this station.
4
Press PROGRAM again to confirm the setting.
PROG disappears, the preset number and
the frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations.
You can override a preset station by storing
another frequency in its place.