Table of Contents
Advertisement
14.2 WEEKLY MAINTENANCE
Every week a specialised person must grease all the
necessary points on the machine and also perform a general
machine check.
In particular, make sure:
- the mixer and agitator shaft seals are in good condition;
- the fl exible coupling in the hopper and the eccentric screw
drive bolt are in perfect condition;
- the delivery manifold is clean and not worn, the pressure
gauge is operational;
- the air fi lter is clean - replace it if needed;
- the compressor belt is in good condition and correctly
tensioned;
- the engine and hydraulic system radiators are clean;
- the battery is charged, the level and specifi c gravity of the
electrolyte are correct.
Also make sure that:
- the pipes, connections and respective gaskets and
supports are in good condition and properly tightened;
- the distributor, solenoid valves, pressure gauges and
pressure switches are operating correctly;
- in general, that the entire machine and relevant
accessories are perfectly operational.
All the indications regarding the type and frequency of
intervention given in the Diesel engine operation and
maintenance manual must be respected
After the rst 50 hours, in addition to the maintenance
operations indicated in the diesel engine manual, and
in particular, oil change, oil fi lter change and diesel fi lter
change, alternator belt, change the compressor oil and the
hydraulic circuit oil fi lter.
14.2 SIX-MONTHLY MAINTENANCE
Every six months arrange for an inspection of the
machine by an authorised IMER service centre.
- Spent oil is a special waste. Therefore it must be
disposed of according to current legislation.
- Always keep notices and symbols on the machine
legible.
In particular, every 500 hours or 6 months (whichever comes
fi rst) have the hydraulic system fi lter changed and every
1000 hours or 1 year (whichever comes fi rst) change the
hydraulic fl uid and compressor oil.
15. REPAIRS
MAINTENANCE OILS AND GREASES
CODE
DESCRIPTION
2246869
HYDRAULIC FLUID "OSO 46"
3225358
DIESEL ENGINE OIL "SUPER DIESEL MULTIGRADE 15W40"
3225364
COMPRESSOR OIL " DICREA 150"
2246890
GREASE "GR MU3"
- Repair, maintenance or lubrication operations
must always be carried out with the machine stopped
and the engine switched off, except for the greasing
indicated in par. 14.1.
All maintenance operations, except for daily maintenance
in any case to be carried out by professionally qualifi ed
personnel, can only performed by specialised personnel.
Use exclusively original IMER spare parts; modifi cations
to parts are strictly prohibited.
- If any guards are removed for repairs, ensure they
are correctly refi tted at the end of work and check the
operation of protection devices.
IMER INTERNATIONAL S.p.A.
PRESTIGE
NOTE:
IMER INTERNATIONAL reserves the right to modify the
characteristics of the plastering machine and/or contents of
this manual, without the obligation to update the previous
machine and/or manuals.
16. FAULTS
If any electrical or electromechanical components fail, the
following led
control panel to indicate the type of failure.
34
lights up and fl ashes intermittently on the
Advertisement
Table of Contents
