ISE 4200094 Assembly/Installation Instructions

Assembly & Installation Instructions:
Keyboard Platforms:
Parts Included
A
Keyboard Platform
Qty: 1
Swing Platform
Required
Leader Standard or Sit-Stand Keyboard Arm with Track
Note: Mount your Leader Arm with Track to your worksurface using the instructions that came with your Leader
Arm.
1
Mount Keyboard Platform to Arm
1.1 Place the Keyboard Platform (A) on the keyboard
arm and align the four holes on the platform with
the four holes in the Arm.
1.2 Insert the #10-32 × ½" Flat Head Screws (B)
through holes on platform, through the holes in
the arm and fasten using four ⅜" #10-32 Keps
Nuts(C). Tighten securely using Phillips head
screwdriver.
2
Attach Cable Clips and Route Keyboard and Mouse Cords
Note: Make sure your keyboard arm is fully
extended before routing your cables.
2.1 Place one Cable Clip (D) on the side of the arm
mechanism. Place the other Cable Clip on the
rear of the track. Do the opposite side in the
same fashion if cords run down the left side.
Caution: Adhesion is designed to bond
immediately. You will not be able to
reposition the clip once it's in place.
2.2 Route the Keyboard and mouse cords through
Cable Clips and be sure to leave enough slack
in cord to allow for unrestricted movement of
the mouse.
1 of 2
or
Swivel Platform
Hardware Kit: #4200094
B
#10-32 × ½" Flat
Head Screw
Qty: 4
D
Cable Clips
Qty: 4

Tools Required

Wrench with ⅜" socket
#2 Phillips screwdriver or drill/driver
5 mm & 5/ 3 2" Allen Wrenches to convert to left handed
A
Swivel Platform shown
2.2
D
Cables will be out of the way
when platform is in use
Under Worksurface
Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
C
⅜" #10-32 Keps Nuts
Qty: 4
E
Friction Pads
Qty: 2
B
1.2
Worksurface
1.1
C
Arm fully extended
2.1
D
Keyboard Arm
2.1