BenQ ST4301K Installation Manual page 28

Byte1=0x01: IP
Address
Byte1=0x02: Get
Subnet Mask
Byte1=0x03: Default
Gateway
Byte1=0x04: Primary
DNS
Byte1=0x05:
Secondary DNS
Byte1=0x06: MAC
Address
(2) Byte2~9 are reserved,
should be 0x00.
Return value: Byte1 - Byte2 -
Byte3...Byte9
The Byte1 at the return value
should be the same as the
value of Byte1 at Input value.
Byte2~Byte15 should be hex
value format
(1) If Byte1=0x00(IP Setup
Mode) at Input value, the
return value should be
Byte1=0x00
Byte2=0x00: Manual
DHCP
Byte3~9 are reserved,
should be 0x00.
(2) If Byte1=0x01(IP Address)
at Input value, the return
value should be
Ex: IP
address=169.254.81.38
Byte1=0x01 (same as
Byte1 at Input value)
Byte2=0xA9 (=169),
Byte3=0xFE (=254),
28
Byte1=0x01: IP
Address
Byte1=0x02: Get
Subnet Mask
Byte1=0x03: Default
Gateway
Byte1=0x04: Primary
DNS
Byte1=0x05:
Secondary DNS
Byte1=0x06: network
MAC Address
Byte1=0x07: Ethernet
(RJ45) MAC Addess
(2) Byte2~9 are reserved,
should be 0x00.
Return value: Byte1 - Byte2 -
Byte3...Byte9
The Byte1 at the return value
should be the same as the
value of Byte1 at Input value.
Byte2~Byte15 should be hex
value format
(1) If Byte1=0x00(IP Setup
Mode) at Input value, the
return value should be
0x01: Byte1=0x00
Byte2=0x00: Manual
DHCP
Byte3~9 are reserved,
should be 0x00.
(2) If Byte1=0x01(IP Address)
at Input value, the return
value should be
Ex: IP
address=169.254.81.38
Byte1=0x01 (same as
Byte1 at Input value)
0x01: